9-pin Universal Heavy Duty T-Harness

This multi-adapter harness kit is used for connecting the Geotab GO tracking device. For use in many heavy-duty international vehicles and comes with 4 various mounting adapters.

Purpose:

Used to connect to the diagnostic port of your vehicle
Used to extend the placement of the tracking tracking device and moves the device out of the way
Allows for semi-convert and inaccessible installation

Length: 39 inches (100 cm)

Max length of connected cables: 6.5 feet (2 meters)

Why 9-pin straight harness model HRN-DS09S4 is required

This 9-pin straight harness model HRN-DS09S4 is required to connect Geotab GO tracking device to a North American heavy duty engine diagnostics (Deutsch connector) port.

Used to extend the placement of the tracking device.
This harness moves the tracking device out of the way of the driver.
Allows for convert installation. Once installed, the Geotab GO tracking device is not visible, out of sight and inaccessible to drivers and thieves.

How to Install 9 Pin Heavy Duty Extension Harness for tracking device

Locate the diagnostic port, usually found under the dashboard on the driver’s side. Identify the type of port connection, either screws or snaps. Remove the screws or unsnap the port. Connect one end of the 16-pin harness to the diagnostic port.
Connect the device to the other end. You will see two lights on the device will flash briefly.
Secure the device in place with a zip tie.
[With the vehicle parked outdoors to locate satellites and vent exhaust fumes], turn on the ignition. The LED will start flashing. Red indicates power. Blue indicates GPS latch. Green indicates cell connection. Wait for all LEDs to come on. Once all LEDs are solid the device should be connecting properly.
Zip tie the harness and the device up under the dash to a permanent location. To ensure quality of data, the device must not move in any way under the dash. Select the correct plate that fits the port and screw or snap into place. The installation is complete.